10
2 - Machine Operation
1. Turn PUMP switch on. Pull the lever on the cleaning tool to
release air in the line. Hold lever until a steady flow of water
comes out of the tool.
2. Turn on HEATER switch and wait a few minutes for water to
heat up.
3. Once water is heated, turn on VACUUM and begin cleaning.
♦
2.7 - Using the Blower Attachment
Attach vacuum hose via Cuff-Lynx™ adapter to the blower port
on the front of the machine in the bottom-right corner. Switch
on the
VACUUM. The blower attachment uses the exhaust from
the vacuum for drying.
♦
2.8 - Using Auxiliary Chemical Bottles
Put desired chemical in the bottle(s) to be used. Connect shop
air to the air line input quick connect in the bottom right corner
of the rear of the machine. Once the bottle(s) are pressurized,
chemical can be sprayed using the attached nozzles.
♦
2.9 - Emptying the Recovery Tank
Pull up on the drain valve handle on the rear of the machine to
drain the recovery tank into a bucket or drain.
♦
2.10 - Storage
When storing the Prep Center S, make sure all liquid is purged
from the system and the tanks are drained. This is especially
important in cold climates.
♦
Use only low foam or non foaming detergent or
shampoo. Damage due to excessive foam will void
warranty.
Empty the vacuum tank any time you refill the
solution tank in order to prevent vacuum tank
overfilling.