Myria MG7401, User Manual

Page: 12 / 16

3
MG7401 - User manual GB
IV. Function
4.1 Key Map (no memory stored)
4.1.1 Key map introduction
1. Key map buttons: X/4, B/2, Y/1, A/3, LB/5, LT/7, RB/6, RT/8;
2. Key mapped buttons: L-wing(Y-), R-wing(Y+), Foot accelerator (RT/Y+), foot brake
(LT/Y-), LS/11, RS/12, Gear-shift (LT/7, RT/8);
4.1.2 Key map setting
1. Press BACK/9+START/10 button and hold on for 3s till the LED light Green. 2. Press
will mapped keys till the Green LED blink;
3. Press the map keys, Green LED off to completed the key map setting
4.1.3 Key map clearance
1. Press BACK/9+START/10 buttons 3 seconds until LED Green lighting
2. Press Mapped buttons until Green LED blinked
3. Press Mapped Buttons again, Green LED off to clear mapped keys function
4.1.4 Clear all Key map function
1. Press BACK/9+START/10 buttons, Keep 3s until LED green lighting
2. Press START/10 buttons for 4s till Green LED off, all the mapped buttons are cleared
to default status.
Note: All settings will be cleared after the wheel power off
4.2 Sensitivity Adjustment
The wheel with three sections of sensitivity – High, Middle & Low.
1. Press and Hold the BACK/9+START/10 buttons for 3 seconds(Green LED will light
up)
2. Press BACK/9 button to display the current sensitivity status
3. Repress the BACK/9 button again to change the sensitivity.
Middle (Green-LED flash)

Highest (Green-LED flash quickly)

Lowest (Green-LED
flash slowly)
4. Press the UP button on the D-pad to confirm and quit.
Note:
1. Pedal is analogical functioned under Digital Mode. The lower the pedal is
pressed, the larger the value varies and the higher the LED blinking frequency is.
2. All the settings will be cleared when the wheel power is cut off.
V. Function
5.1 PC on PC
5.1.1 Mode shift
1. Default mode X-INPUT, red mode LED lighting
2. Press MODE button 3s, switch to D-INPUT mode, red mode LED lighting
5.1.2 Driver Install
1. Enter into Windows Vista/7/8/10

Insert the supplied Driver CD into your PC CD-
ROM, Double click the SETUP icon, then follow the instructions to start installation: