© 2019 mPTech
. All rights reserved. myPhone Prime 3 Lite
11
7. Before the first start
7.1 Mounting the SIM card.
The device is a cellular phone made in Dual SIM technology (2 SIM cards
handling) allowing the use of two mobile networks simultaneously.
To insert the SIM card(s) correctly, turn off the device, open it with your
fingernail and gently remove the case. Insert the SIM card(s) into the slot(s) (17)
as shown next to the slots. Then carefully replace the cover.
7.2 Installation of the memory card
To insert the memory card correctly, turn off the device, open it with your
fingernail and gently remove the case. Insert the microSD card into the slot in
accordance to the picture (16) placed next to the slot. Then carefully replace
the cover.
Use only memory cards recommended by the manufacturer. Pay attention to
the selection of the proper format-the microSD card, capacity and type/class.
Incompatible memory cards may damage the device and cause the stored data to
be destroyed as well. Incompatibility of memory card can be caused, among others,
by an incorrect card format (required format microSD) or an unsupported card
capacity - above the value recommended by the manufacturer.
7.3 Charging the battery
Use only chargers and wires recommended by the manufacturer. Using
incompatible chargers or cables can cause explosion of the battery or damage
to your device.
Incorrect charger connection (USB cable) can cause damage to the AC adapter
or the device. The damages resulting from improper handling
are not covered by the warranty.
The device can heat up during charging. It is a regular occurrence and should
not affect the stability or performance of the device.
If the phone does not charge properly deliver it (with the charger) to a service
center of the manufacturer.
Charge the battery before the first use. The battery should be charged by the
attached charger or another charger, intended for this type of equipment. If in
doubt contact the seller or manufacturer service.
When the battery is near a complete discharge, the notification is displayed on
a low battery charge. To continue use of the device charge the battery. If the
battery is completely discharged the device can not be switched on even when
the loading process is ongoing.
Before the device can be turned on again, the battery has to be charged for at
least a few minutes. In case of any problems with the battery or if in need of a
replacement, the device should be delivered to the manufacturer's service
