www.mylek.co.uk
5 | Page
•
The appliance should only be connected to the same voltage as
printed on the rating label and manual.
•
If used as a portable heater do not use in the immediate
surroundings of a bath shower or a swimming pool.
•
WARNING: In order to avoid overheating, do not cover the
heater.
•
Never place foreign objects into the air vents.
Installation:
Floor Standing:
•
The heater carries an IP22 waterproof rating, If this unit is to be fitted in a bathroom then
it must be “INSTALLED BY A QUALIFIED ELECTRICIAN”.
•
The LCD panel heaters can be wall-mounted or floor standing.
•
Mount feet on the base of the unit using the 6 screws provided (3 screws per foot) in
accordance with Figure 1 below making sure the screws are securely tightened.
Figure 1
Wall Mounting:
•
For wall mounting, carefully remove the already constructed hanging bracket from the rear
of the heater by turning the two plastic securing grips located at the top of the bracket. It is
good practice to remove the bracket and replace a few times so you are familiar on how it
attaches before securing to the wall.
•
Using the hanging bracket as a template, place the hanging bracket level against the wall
as a guide ruler (please make sure the holes are parallel level), use a marker pen to mark
the hole position. Image 2 on Figure 2 below.
•
Drill holes on the wall with
ɸ
8mm drill bit and insert the plastic wall plugs. Image 2 on
Figure 2 below.
Summary of Contents for MYC01-10A
Page 15: ...www mylek co uk 15 Page...
