www.hsdonline.co.uk
5
OPERATION
SETTING UP
1.
Plug the mains lead into a 13A mains socket.
2.
Move the power switch to “on” position.
HEATING
1.
Press the
Setting Button
[3] once to enter power adjustment mode, the unit will
bleep and
Power Level Indicator
[9] will flash to display the current power level.
2.
Use the
Up
[4] and
Down
[5] buttons to cycle through the power settings.
3.
When the desired power level is displayed, do not press any buttons on the display
until the
Power Level Indicator
[9] stops flashing. The power level is now set.
4.
The
Temperature Display
[8] shows the set temperature.
Press
Up
[4] or
Down
[5] once, the display will begin to flash and show the target
temperature. Press
Up
[4] or
Down
[5] to adjust the target temperature by 1°C
(range: 5°C
–
45°C). Press and hold these buttons to quickly adjust the temperature.
Once the desired target temperature is flashing, do not press any buttons on the
display until the display stops flashing. The target (set) temperature is now set.
5.
If the set temperature is below the room temperature, the radiator will not produce
heat.
If the set temperature is above the room temperature, the radiator will switch on
and the
Power Indicator
[7] will be illuminated.
TIMER SETTING
The radiator can be set to start-up or shut-down after a timed interval. To set the shut-down
time:
1.
During normal operation press the
Timer Button
[2] to enter timer set up (press
again at any time to
cancel
the timer set up) and the
Timer Display
[8] will flash