www.hsdonline.co.uk
Power tool use and care
1. Do not force the power tool. Use the correct power tool for your application. The
correct power tool will do the job better and safer at the rate for which it was
designed.
2. Do not use the power tool if the switch does not turn it on and off. Any power
tool that cannot be controlled with the switch is dangerous and must be
repaired.
3. Disconnect the plug from the power source and/or the battery pack from the
power tool before making any adjustment, changing accessories or storing
power tools. Such preventive safety measures reduce the risk of starting the
power tool accidentally.
4. Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
5. Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired before use. Many
accidents are caused by poorly maintained power tools.
6. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
7. Use the power tool, accessories and tool bits etc. In accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
Battery tool use and care
1. Endure the switch is in the off position before inserting battery pack. Inserting
the battery pack into power tools that have the switch on invites accidents.
2. Recharge only with the charger specified by the manufacturer. A charger that
is suitable for one type of battery may create a risk of fire when used with
another battery pack.
5
MYW09_18V_Drill_Manual 12/12/19 11:58 Page 5
Important: Please note this unit is not a hammer drill and should not be used
as a hammer drill. Doing so and drilling into the wrong materials could cause
the drill to overheat and become faulty. Please use the drill only as intended
and shown in these manufacturers instructions.
Important: When pressing the trigger ,the cordless drill will spark at the rear
body of the drill. This is a normal function which is caused as the carbon
brushes pass by the commutator. These small sparks are a normal function
of a brushed cordless drill operation.
8
.
9
.
