MYGALE
Technopole - 58470 Magny-Cours - France
Tel : +33 (0)3 86 21 86 21
Fax : +33 (0)3 86 21 86 22
7/58
3.2
S
ET
U
P
A
DJUSTMENT
Values are theoretical, assembly dispersion is possible.
3.2.1
R
IDE
H
EIGHT
C
HECK
&
A
DJUSTMENT
The reference points for calculating the ride height are shown below.
The vehicle reference plane is the lower side of the wood floor. The skid block is below this. The
choice of ride height needs to take account of the skid block thickness which is a maximum of 5mm
below the reference plane (and minimum 2mm).
The diagrams refer to the dimensions from the chassis reference point to the reference plane.
At the front two ride height adjustment screws (F.41.35.001) must be fix on the two reference pads
which are machined into the upper surface of the monocoque and are accessible with the damper cover
removed.
At the rear the reference surfaces are machined pads on the gearbox upper surface, at the level of
the damper bracket and are accessible with the engine cover removed.
Front reference Rear reference
The front reference dimension A1 is 441mm.
The rear reference dimension A2 is 369mm.
