2. Wax clasp using 12 gauge sprue wax. Wax connection to
framework incorporating two or three squares of meshwork.
3. Trim excess wax away.
Clasps should be as close to 2mm x
2mm as possible.
This size is important to ensure complete
injection of the
DurAcetal
.
4. Using a black felt-tip marker, place dashes on the facial and
tongue or roof area of the model. When aligned, these dashes
correspond to the tip of each clasp.
5. Mix one scoop of CDM brand Extra Hard Putty A with one scoop
of putty B. Mix the putty until consistent. Place the putty on the
occlusal surface and work down over the buccal and lingual
covering the clasp. When the putty is in place, observe the lines
created in step 4 to estimate where the tip of the clasp is. Using
the Elite Putty Tool, indent down to the base of the tool. Repeat
this step when creating two clasps making sure the first putty
matrix is set as not to move or warp it.
7
myerson HOTSHOTELITE MANUAL ENGLISH.indd 7
3/23/10 9:54:29 AM
