SP75 Series
Submersible Sump Pumps
INSTALLATION, OPERATION, & PARTS MANUAL
SAFETY INFORMATION
Carefully read and follow all safety instructions in this
manual or on pump.
This is the safety alert symbol.
When you see this
symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for
personal injury!
warns about hazards that
will
cause serious
personal injury, death or major property damage if ignored.
warns about hazards that
can
cause serious
personal injury, death or major property damage if ignored.
warns about hazards that
will
or
can
cause
minor personal injury or property damage if ignored.
The word
NOTICE
indicates special instructions which are
important but not related to hazards.
Electrically powered sump pumps normally give many years
of trouble-free service when correctly installed, maintained,
and used. However, unusual circumstances (interruption of
power to the pump, dirt/debris in the sump, flooding that
exceeds the pump’s capacity, electrical or mechanical failure
in the pump, etc.) may prevent your pump from functioning
normally. To prevent possible water damage due to flooding,
consult your dealer about installing a secondary sump
pump, a DC backup sump pump, and/or a high water alarm.
See the “Troubleshooting Chart” in this manual for informa-
tion about common sump pump problems and remedies.
1.
Know the pump application, limitations, and potential
hazards.
2.
Disconnect power before servicing.
3.
Release all pressure within system before servicing any
component.
4.
Drain all water from system before servicing.
5.
Secure discharge line before starting pump. An unse-
cured discharge line will whip, possibly causing personal
injury and/or property damage.
6.
Check hoses for weak or worn condition before each
use, making certain that all connections are secure.
7.
Periodically inspect sump, pump and system compo-
nents. Keep free of debris and foreign objects. Perform
routine maintenance as required.
8.
Provide means of pressure relief for pumps whose dis-
charge line can be shut-off or obstructed.
9.
Personal Safety:
a. Wear safety glasses at all times when working with
pumps.
b. Keep work area clean, uncluttered and properly light-
ed – replace all unused tools and equipment.
c. Keep visitors at a safe distance from work area.
d. Make workshop child-proof – with padlocks, master
switches, and by removing starter keys.
10. When wiring an electrically driven pump, follow all elec-
trical and safety codes that apply.
11. This equipment is only for use on 115 volt and is
equipped with an approved 3-conductor cord and
3-prong, grounding-type plug.
© 2008
MY502 (Rev. 2/20/08)
Individual
Switch Setting
Model
Motor
Max.
Branch Circuit
Cord
in inches (mm)
Number
HP
Load Amps
Required (Amps)
Length
On
Off
SP75P1
3/4
7.5
15
10’
11" (279)
3-1/2" (89)
SP75PC1
3/4
7.5
15
20’
11" (279)
3-1/2" (89)
SP75MC1
3/4
7.5
15
20’
–
–
MOTOR, SWITCH, & CORD SPECIFICATIONS
1101 Myers Parkway
Ashland, OH 44805
Phone: 1-419-289-6898
Fax: 1-419-289-6658
Web Site: http://www.myerspump.com