Setup & Testing
Test Procedure
Prerequisite:
zappi
is installed, turned ON and charging set to FAST MODE.
1.
Connect
zappi
to the
EVSE test box
.
2.
Connect the electrical tester to the test terminals.
3.
Move the connector selection switch to the adequate connector (type 1 or type 2).
4.
Set the
EVSE test box
to
charging
using the selector knob.
5.
Run the RCD test using your own electrical tester.
6.
At each tripping event, reset the
zappi
by holding the “Mode” (or
exit
) button for 5s as indicated on the main
screen.
zappi
will automatically reset & the next test will proceed.
7.
At the end of the test, move the knob back to
disconnected
and disconnect the plug.
installer manual
EVSE Test Box
3
1