MyBinding IDEAL 4850-95 EP, Instruction Manual

Page: 11 / 18

IDEAL 4850-95 EP; IDEAL 5221-95 EP; IDEAL 6550-95 EP
10
01-01-23 B5221G1A doc
4. Maintenance
s
Danger
- Maintenance work may only be performed by
trained staff.
- Replacement of blade and cutting stick may
only be performed when the main switch is
switched off.
- Disconnect from the mains before starting
any service work or before removing the
cover.
Safety check
Perform a safety check every 5 years according
to § 40 VBG 7i according to test specification
EBA WN 105 18 61. The execution of this
safety check must be confirmed on the test
protocol. A test badge must be fixed to the rear
of the machine.
4.1 Cutting stick replacement
If the last sheet of paper of a stack is not
completely cut, the cutting depth must be
adjusted.
Setting the cutting depth
- Turn the screw (9) a half turn to right.
- Perform cutting test as described below
If the cutting stick (2) is very worn it must be
turned.
l
Warning!
Too deep cutting into the cutting stick
shortens the life time of the blade.
Turning or replacing the cutting stick
- Turn the screw (9) to the left until it stop.
Then a turn to the right.
- Dismount cutting stick (2).
- Turn the cutting stick (the non-used side must
be close to the blade) and plug it into the
holding bolt.
The cutting stick can be used eight times.
Cutting test
- If the last sheet of paper of a stack is not cut
over its total length, Turn the screw (9) a half
turn to the right.
- Repeat this procedure until the paper is cut
over its total length.