MyBinding GBC SignMaker 25, Installation & Operation Manual

Page: 16 / 35

Operating Instructions
Page 5-2 ©2004 General Binding Corporation
S
IGN
M
AKER
25/44
D. FEED TABLE:
The Feed Table, Fig 3, is used to position items for lamination. The lami-
nator will operate only when the Feed Table and Feed Table Latch
are properly installed.
E. SAFETY SHIELD:
Prevents entanglement, entrapment and inadvertent contact with the
heat rollers. T
he laminator will operate only when the Safety Shield is
located in the fully locked position. Power to the motor is removed
when the shield is removed.
F. TABLE INTERLOCK LATCH:
Used to lock the Feed Table into position and activate an interlock switch.
The interlock latch is located on the left underside of the Feed Table, (Fig
3).
The table cannot be removed without retracting the latch to the
right while lifting the table upwards and away from the laminator.
The laminator will not operate when the table is removed and/or the
interlock latch is retracted.
G. FEED GUIDE:
The Feed Guide, Fig 3, permits alignment of the item(s) to be laminated.
To position the adjustable guide, loosen the knob on the top of the guide,
slide it to the desired position and tighten the knob to secure the Feed
Guide in place. The Feed Guide is used to keep longer items straight.
The Feed Guide may also be used to feed smaller items side by side by
positioning the guide towards the center of the Feed Table and placing
smaller items against each side of the Feed Guide as they are being
introduced into the nip point of the heat rollers.
Fig. 3