4
MyAmplifiers.com - +44 977215553 (UK) , +33 977215553 (France),
E-mail:
-
Skype:
gsm_amplifier
www.myamplifiers.com
5. Operation instructions
5.1.
Descriptions of the overall dimension of the equipment
The whole-set shape is shown as follows:
RF Port BTS Port
（
Uplink input, Downlink output
）
connected with reverse antenna facing to the base
station.
RF Port User’s Port
（
Uplink input, Downlink
output
）
connected with indoor covering system
Install Bracket
Power interface
Power indicator light
5.2 Instructions on installation
1. Firstly, select an appropriate position to mount. The
signal amplifier is better to be mounted close to
walls. At the position selected, punch a hole in the
wall as shown in the diagram and aim the bolt at the
hole. Then fasten and fix with expansion bolts.
2. Connect the BTS Port (in the diagram) with out door
reverse antenna through radio frequency cable. In
general, the reverse antenna is mounted at a higher
position. Yagi antenna and panel antenna may be
used. The main lobe of the antenna radiation is
oriented towards the base station and the reverse
antenna and base station antenna should be visible
as possible.
3.
Connect User’s Port (in the diagram ) with the ports
of indoor covering system or indoor relay antenna.
In general, the indoor covering system is composed
of several splitters, couplers, expansion amplifiers
and antennas and applied as per specific
engineering design for the purpose of satisfying the
signal covering demands in large area or
complicated terrain indoor space. In the case of
small area indoor space, the requirements for
covering can be satisfied by using single relay
antenna with the option of hanging antenna or
ceiling antenna.
4. Finally, connect the power interface shown as in the
diagram to 5V8A power adapter and power on the
adapter with 220v AC. The signal amplifier
installation is thus completed.
5.3. Debugging and commissioning
