11. FITTING THE DOUBLE INTERLOCK HOSE & HANDSET
1. Connect one end of the double interlock hose to
the outlet, making sure that the sealling washer is
in place .
2. Pass the doulbe interlock hose through the hose
retaining ring then screw onto the handset using
the washer. Carry out a leak test (Fig18).
3. MX provide an eco flow controller with every
handset they sell. This reduces the flow of water at
high water pressures. If you require, fit between the
handset and the hose.
NOTE: It is the conical end of the double interlock
hose which grips into the handset height adjuster. The
handset will not fit in the height adjuster without the
double interlock hose attahced.
13
10B. FITTING THE RISER RAIL (SQUARE STYLE CONT)
1. Having established the position of the riser rail so
that the showerhead can be comfortably reached
whilst using the shower, make sure any cables and
pipework are not behind the screw holes (Fig 13).
2. Remove caps for the riser rail wall brackets, mark
the position of the hose and drill plug and screw to
fit the two wall brackets. Fix lower braket to wall
(Fig 14).
3. With the handset height adjuster on the left hand
side, fit the hose retaining ring and then soap dish
onto the bottom of the rail assembly. Replace the
rail assembly onto the lower bracket. Fit top bracket
to rail and screw wall and replace both end caps
(Fig 15 & 16).
14
15
16
18
Round Style
Square Style
