MX Atmos Energy, Fitting Instructions Manual

Page: 8 / 16

9. FITTING THE MIXER VALVE
7. Complete the fitting of the pipework and the tiling
leaving the pipework as shown. Leave 155mm
(+ or - 5mm) between centers and about 30mm
out from the finished surface (Fig 4).
8. Remove the back plate from the mixer valve by
removing the retaining grub screws. Put the plate
in the centre between the feed pipes and mark the
screw positions, check this fits by holding the valve
in position. Drill plug and screw the back plate to
the wall (Fig 5).
9. Fit the two flat valve nut covers to the nuts on the
mixer valve and position the mixer valve onto the
two water feed pipes and onto the wall bracket.
To prevent moisture entering the wall put some
silicone on the underside of the mixer valve nut
covers. Carefully tighten up the compression nuts to
hold the mixer valve in place (Fig 6).
10. Make sure the mixer valve outlet is pointing in the
correct direction (with the hot feed on the left side
marked with a red indicator). Replace the locking
grub screws to hold the mixer valve onto the wall
plate..
6
5
4