5
*Operating Instructions
When using the unit for the first time, leave the unit in room temperature for half of an hour
before running (Especially when the outdoor temperature is lower than 5°C).
It is recommended to use the unit within a temperature range of 5-40°C, relative humidity of
less than 80%RH.
Use clear water not over 40
°
C.
Check the water basin, to make sure it is clear.
Operation steps:
1. Take the water tank (3) out of the base (7),
2. Twist the Valve-cap to LOOSEN (4)
3. Fill the water tank (3) with clear water
4. Twist the Valve-cap to FASTEN (4)
5. Put the water tank (3) onto the base (7) carefully
6. Put the Nozzle (1) into the socket on top of the water tank (3)
7. Connect the adapter to the unit, switch on the unit (NEVER RUN THE UNIT WHEN THERE
IS NO WATER IN THE WATER BASIN)
8. The indicator light will flash once with one beep. The unit will be in standby mode.
9. To adjust the pressure of misting:
a. Press control button once for a higher pressure mist. The unit will beep once.
b. Press control button a second time for lower pressure misting. The unit will beep twice.
c. Press control button a third time to switch the humidifier off. The unit will beep once,
and the control button light will turn off.
10. This device is now ready for use.
NOTE When there is not enough water in the tank, the unit will stop working automatically with
the red indicator light flashing and the unit will beep for 20 seconds
Instruction Manual.indd 5
2020/05/14 12:43
