![background image](http://html1.mh-extra.com/html/mwh/fta90548/fta90548_owners-manual_1861105033.webp)
Turn LP gas tank to “ON” at valve
Check for leaks at these locations:
Lighting
WARNING: NEVER light the burner with the cover on the outdoor fireplace.
CAUTION: Keep outdoor gas appliance area clear and free from combustible materials, gasoline and
other flammable vapors and liquids.
CAUTION: Do NOT obstruct the combustion and ventilation air.
CAUTION: Check and clean burner/venturi tubes for insects and insect nests. A clogged tube can
lead to a fire.
1. Make sure all labels, packaging and protective films have been removed from the outdoor fireplace.
2. Check for obstructions of airflow to the burner. Spiders, insects and webs can clog the burner/
venturi tube. Aclogged burner tube can lead to a fire.
3. Control knob must be in the “ OFF” position .
4. Clear small area of glass rocks away from the igniter cover .
5. Connect LP gas tank per “Installing LP Gas Tank” section.
6. Turn LP gas tank valve to “OPEN”.
7. Push and hold the electronic igniter to create sparks within the electrode, continue to hold.
8. Push in the control knob and turn to the “ON” position, Keep holding down the control knob to al-
low gas to flow for 20 seconds.
9. After 20 seconds, release and turn control knob counterclockwise to adjust flame to desired
height.
10. If ignition does not occur in 20 seconds turn burner control knob to “ OFF” wait 5 minutes, fan
with a newspaper or magazine, and repeat lighting procedure.
11. Remove cover and lid from outdoor fireplace before lighting.
12.If igniter does not light burner
a. Wearing heat-resistant gloves, position a long lit match or long lit butane lighter near the pilot
housing.
b. Push and turn contorl knob to “ON ”
C. Remove match/lighter once burner is lit
CAUTION: After lighting - using a fireplace tool and heat-resistant gloves, carefully move the glass
beads back to their proper, position, being careful to avoid the flame.
13. After lighting, observe the burner flame make sure all burner ports are lit and flame height
matches illustration(Figure 5)
CAUTION: If ignition does not occur in 5 seconds, turn control knob to “ OFF”, wait 5 minutes, fan
with a newspaper or magazine and repeat lighting procedure.
Turning off
1. Turn LP gas tank valve to “ CLOSED”. 2. Turn control knob to the “ OFF” position. Note: A “poof”
sound is normal as the last of the LP gas is burned. 3. Disconnect LP gas tank per “Disconnecting LP
Gas Tank” section
OWNERS MANUAL
Summary of Contents for FTA90548
