7
＊
Insulate the working area since spatter will be occurred.
＊
No access to switching or modulating by others while the cutter is working
＊
Cutters have strong electromagnetism and frequency interference, so keep away people with heart pace or the
articles which can be interfered by electromagnetism and frequency.
＊
No squeeze or punch to the cutting cable.
＊
Never clean the slag in the torch head by violent knocking.
＊
The puckering angle of the torch cable can not be too small, otherwise the inside cable of gas pipe will be
damaged which can result into accident.
＊
Never allow anybody else other than the operator himself to access the job site.
＊
No touching on the output connection or any other electrification parts while welding.
Safety Measures to Be Taken To Assure the Correct Installation and
Position
＊
Precaution must be taken to keep the operator and the machine from the foreign materials falling from up
above
＊
The dust, acid and erosible dirt in the air at the job site can no exceed the amount required by the norm
(excluding the emission from the cutter).
＊
The cutting machine must be installed in the place where it can no be exposed to sun and rain. Also it must be
stored in less humid place with the temperature range at -10
～
+40
℃
.
＊
There should be 50cm space left for the cutting machine to have good ventilation.
＊
Make sure that there is no metal-like foreign body to enter the cutting machine.
＊
No violent vibration in the cutter’s surrounding area.
＊
Make sure the machine is installed in where it won’t interfere the surrounding electromagnetism equipment
during the operation.
＊
Take measures to prevent wind while operating in the strong wind since the cutter
is
gas shielded.
Safety Check
Each item listed below must be carefully checked before operation:
＊
Make sure that the cutting machine has reliable earth connection.
＊
Make sure that there is always sound output and input wire connection instead of exposing outside.
Regular check needs to be conducted by the qualified personnel after the cutter has been installed over a
period of six months, which involves as follows:
＊
Routine cleaning is required to make sure there is no abnormal condition happening in the tightened places
such as the loose and slipped magnetic core, regulating screw, connecting wire happening in the cutting
machine.
＊
The external parts installed on the cutter’s panel must guarantee that the welder works properly.
＊
Fresh the cable of the cutter if it is worn out..
＊
Any damage to the input cable if occurred should be dealt safely.
＊
Make sure whether there is enough power supply to make the cutting machine work properly, and the power
supply connected into the cutter should be equipped with safety protection device.
Notice: Cut off the power supply before opening the case to check.
Please do not hesitate to contact us for technical assistance whenever you come across the problems you can
not work out or you may deem difficult to fix.
