26
Ice thickness control
There are three steps to adjust ice cube thickness.
1.
The
float switch
is installed
in
'Normal' mode
at the factory
. There are 4 protrud
ing
buttons on the
water trough
and 6 holes on the bracket.
To
adjust
the ice thickness, detach the float switch bracket
from the
water
trough
and adjust
per instructions below.
2.
To make ice cube thinner or thicker, change the hole's location
to
mov
e
up or
down. (Please refer to the below picture)
To make thinner : Place
float bracket into
first 4 holes of
the water
trough, last 2 holes remain open.
)
To make thicker : Place
float bracket into last 4 holes of the water
trough, first 2 holes remain open.)
Bracket float switch
NORMAL
THICK
THIN
Summary of Contents for KOOL-IT KCU-180-AH
Page 34: ...34 Memo ...
Page 35: ...35 Memo ...