8
Inserting a second SIM card:
REMOVING THE SIM CARD
Follow the steps below to remove either of
the SIM cards from your terminal.
➊
Switch the device off.
➋
Unscrew the center cover.
➌
Push in then release the SIM card to remove
it from the slot.
➍
Screw the cover back on.
➎
Switch the device back on.
ELECTRICAL CONNECTIONS
The terminal can be powered in two ways:
•
Power supply through the 12-24 V DC
socket.
•
24 VDC Power over Ethernet (PoE) connec-
tion using a passive injector.
Stay at least 20 cm away from the termi-
nal when it is switched on.
If you have the PoE option, do not con-
nect the PoE injector and the standard
power supply at the same time.
For passive PoE power supply, do not
connect/disconnect the power cable when
the injector is on.
Before installing the terminal blocks and
plugging in, the cable(s) used must be
threaded through the
cover’s grommet (one
cable per gland).
The grommets are delivered unpierced. The
cable must be pushed through to open the
grommet at the center. When using PoE, do
not puncture the unused grommet.
Never remove the SIM card when the
terminal is switched on, as this may
damage the card and/or the terminal.
EMI Suppressor Ferrites must be installed on
each cable, at the output of the device.
Typical Impedance on each cable:
3 kOhm at 100 MHz
1.5 kOhm at 25 MHz
(e.g. 12 ferrites No. 7427007 from Würth
Elektronik).