o p e r a t i n g t h e m c d - 1 0 0 0
Operating the MCD-1000 is very similar to operating a home-type CD player, however Muzak discs are a
proprietary
format
which will not play on consumer audio CD players.
Consumer audio CDs will not play on the MCD-1000.
1.
Attach the enclosed AC power cord to the AC inlet on the rear panel.
2.
Plug the AC power cord into a grounded (3 prong) 120 volt AC outlet. DO NOT REMOVE THE ROUND GROUND
PIN FROM THE AC PLUG.
3.
Press the
power
button.
4.
Press the
open/close
button to open the disc tray.
5.
Place the CD in the tray
label side up
.
6.
Press the
open/close
button to close the disc tray.
7.
The Play LED will flash during disc initialization.
8.
Music playback will begin in about five to ten seconds after disc initialization and the
Play
LED will remain on. If any
LED remains flashing, see
Error Indicaations
on page 15.
9.
Set the
music volume
for the desired volume level.
10.
Set the rear panel
bass
and
treble
controls for the desired tone balance.
CAUTION
— TURNING THE BASS UP TO A HIGH VOLUME MAY CAUSE DISTORTION OR DAMAGE TO THE AMPLIFIER.
11.
The CD will repeat continuously until the
stop
or
open/close
buttons are pressed.
12.
Press the
forward
button to advance to the next music track.
13.
Press the
back
button once to play the present music track over. Press the
back
button twice to start from the
previous music track.
r e m o t e c o n t r o l t e r m i n a l s & b a c k u p s y s t e m h o o k u p
1.
Connect a momentary contact switch or the
backup start output
of a Muzak SS-200 silence sensor between the
MCD-1000
start input
and
ground
terminals.
11
