© MuxLab Inc. 2015
Installation
One splitter and up to 3 audio analog balun (500028) can be used to complete the
system via UTP cable.
Caution:
Do not attempt to open the housing. There are no user-serviceable parts
inside the box. Opening the unit will void your warranty.
Do not connect the unit to a telecommunication outlet wired to unrelated
equipment. Making such a connection may damage the equipment and/or
the balun. Verify that the desired twisted pairs are not being used for
other LAN or telephone equipment.
1.
Use a dedicated 4-pair Cat5e/6 cable between the source and the receiver balun. A patch
panel can also be used.
2.
Verify the wiring is “straight-through”, has 4 twisted pairs and has the standard Ethernet
RJ45 plug.
3.
Each connector (#1, 2, 3& 4) can be used for input or output. Only one source can
be used.
4.
Cascading multiple units is not recommended.
5.
At the destination point, connect the passive balun Audio receiver (or AV receiver)
or Muxlab Amplifier (500219).
Troubleshooting
The following tables describe some of the symptoms, probable causes and possible solutions regarding
the splitter:
Video Symptom
Probable Cause
Possible Solutions
No audio
No continuity
Check continuity on each pair.
Check if pairs are not swapped or reversed.
Check if the four pairs are present.
Equipment off
Check the audio source equipment.
Loss of Hi Frequency
Exceeded distance
Verify total cable length.
Hum or Buzz
Defective cable or
equipment incorrectly
connected or grounded.
Change cable or verify wiring interface.
Try grounding equipment on each side to
safety ground.
If you still can’t diagnose the problem, please call MuxLab Customer Technical Support at
877-689-5228 (toll-free in North America) or (+1) 514-905-0588 (International).
