VJ-1204 INSTALLATION MANUAL
VJ1204E-I-00
6
1
2
1
2
2
1
2
1
(Cont'd)
5. Turn ON the product.
6. The product starts the initial operation.
The operation panel displays "Media End".
7. Push the media loading lever backward.
The operation panel displays "Lever Up".
8. Feed the roll media into the media feed slot.
9. Open the front cover, and pull out the roll media.
10. Press and hold the front edge of the roll media and
wind it back with the scroller to remove a media
bend or slant.
11. Return the media loading lever to the front and
close the front cover.
The operation panel displays the media type setup
menu.
12. Press the [+] or [-] key on the operation panel to select
the type of the loaded media and press the [Enter] key.
This confirms the media type.
The operation panel displays "Media Initial", and
media initial operation starts.
After the media initial operation is completed, the
operation panel displays "Ready to Print", and the
display enters normal status.
13. Wind back the roll media with the scroller to re-
move a media bend.
The media loading is complete.
9 Checking printing conditions
Check the condition of the print head after the ink re-
plenishment.
1. Turn ON the printer and load equal to or bigger
than A3 size of roll media.
8 Loading the roll media
2. Confirm that the printer functions normally.
3. Press the [<] key on the operation panel for two
seconds or more.
Nozzle check printing starts.
4. Check the sample print for blurred or missing
parts in the check pattern.
5. If the nozzle check result indicates that there is a
problem such as mentioned above in the check pat-
tern, clean the head.
Press and hold the [Cleaning] key on the operation
panel for two seconds or more.
The operation panel displays "Cleaning **%".
6. Head cleaning starts.
If one time of head cleaning was not enough to re-
move blurred or missing parts in the check pattern,
perform powerful cleaning.
If those problems above were not improved after a
few times of head cleaning, refer to the Operation
Manual "7 Troubleshooting" and perform required
procedures.
7. Perform nozzle check again and check the condi-
tion of the print head.
10 Manual composition
This product includes the following three manuals.
Installation Manual (this manual)
This manual explains the procedures of unpacking, in-
stalling, and the basic set up.
Quick Reference
Quick Reference is excerpts of functions used daily.
Operation Manual (CD-ROM)
The Operation Manual explains the basic installation,
daily use and applicable functions.
The Operation Manual of this product is created
with the HTML format and can be viewed using
browsers such as Internet Explorer.
Refer to Quick Reference "5.5 Using Operation
Manual CD" for viewing the Operation Manual.
1
2
2
2
1
No.
Name
1
Media loading lever
No.
Name
1
Roll media
No.
Name
2
Media feed slot
No.
Name
1
Front cover
No.
Name
2
Roll media
No.
Name
1
Media loading lever
No.
Name
2
Front cover
No.
Name
1
Roll media
No.
Name
2
Scroller
No.
Name
1
Roll media
No.
Name
2
Scroller
NOTE
TIP
