10
ENGLISH
SPEAKER OUTPUTS CH1-8:
Connect here speakers (2 - 4 Ohms) according to your sound system. A maximum of 8 speakers can be con-
figured based on the system you wish to create in your vehicle.
If you want to bridge the speaker outputs (BTL mode)and drive the connected speakers/subwoofers with a 4
Ohm load, bridge the channels as follows:
Channel pair 1: SPEAKER OUT1+ (+) & SPEAKER OUT2- (-) with 4 Ohms
Channel pair 2: SPEAKER OUT3+ (+) & SPEAKER OUT4- (-) with 4 Ohms
Channel pair 3: SPEAKER OUT5+ (+) & SPEAKER OUT6- (-) with 4 Ohms
Channel pair 4: SPEAKER OUT7+ (+) & SPEAKER OUT8- (-) with 4 Ohms
SPEAKER OUTPUTS
20 pole multipolar connector to manage the amplified speaker output signals and power supply.
7
Do not parallel the outputs, otherwise it may lead the amplifier to damage.
WARNING
Front view
1: BAT –
11: BAT +
2: BAT –
12: BAT +
3: SPEAKER OUTPUT CH 8 –
13: SPEAKER OUTPUT CH 8 +
4: SPEAKER OUTPUT CH 7 –
14: SPEAKER OUTPUT CH 7 +
5: SPEAKER OUTPUT CH 6 –
15: SPEAKER OUTPUT CH 6 +
6: SPEAKER OUTPUT CH 5 –
16: SPEAKER OUTPUT CH 5 +
7: SPEAKER OUTPUT CH 4 –
17: SPEAKER OUTPUT CH 4 +
8: SPEAKER OUTPUT CH 3 –
18: SPEAKER OUTPUT CH 3 +
9: SPEAKER OUTPUT CH 2 –
19: SPEAKER OUTPUT CH 2 +
10: SPEAKER OUTPUT CH 1 –
20: SPEAKER OUTPUT CH 1 +
BATTERY TER/-:
BAT+: Connection terminal for positive (+) power supply from the car specific cable harness
BAT-: Connection terminal for negative (-) power supply from the car specific cable harness
These power terminals are paralleled with the POWER terminals internally. The power cables must be properly
insulated to prevent electrical short. If the POWER terminals are connected with the battery, it is not mandatory
to connect the power supply here.
Summary of Contents for D8v2
Page 1: ...D8 8 CHANNEL CLASS D AMPLIFIER WITH 10 CHANNEL DSP VERSION 1 3 V2...
Page 34: ...34 DEUTSCH...
Page 35: ...35 DEUTSCH...