Mustek POWERMUST 636, Startup Manual, Page: 5 / 32

4
Installation & Initial Startup
NOTE: Before installation, please make sure nothing inside of package is
damaged. To protect your equipment from power failure, be sure that
power switch must be kept in the “ON” position. Following below steps to
install your UPS unit.
EN
Connect to Utility & Charging
Plug in the AC input cord to the wall outlet. For the best results, suggest to
charge the battery at least 4 hours before initial use. The unit charges its
battery while connecting to the utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply
turn on the power switch of UPS unit, then devices connected to the UPS will
be protected by UPS unit.
CAUTION: NEVER connect a laser printer or scanner to the UPS unit. This
may cause the damage of the unit.
Connect Modem/Phone Line
Connect a single modem/phone line into surge-protected “IN” outlet on the
rear panel of the UPS unit. Connect from “OUT” outlet to the computer with
phone line cable.
Connect USB Cable
To allow for unattended system shutdown for your operating system, connect
the
cable as per diagram below. For the USB serial cable, just simply plug
into the UPS and PC and it will be auto detected.
Turning On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit
by pressing again the power switch. You may check the front LED indicators
for the status.
Cold Start Function
When the UPS is off and there is no power utility, it’s still possible to cold
start the UPS unit to power the loads.