5
Installation
Introduction
This unit will deliver the ultimate performance
possible from any phono source .
Cleaning
Before cleaning the unit, switch off power at the
mains switch and remove the mains plug from the
wall socket . Clean the cabinet and remote control
unit using a moist cloth . Using solvents, white
spirit or thinners is not advised, as they could
damage the surface finish.
Installation
Position the M6 ViNYL on a stable, horizontal
surface where there is no risk of it being
knocked, or subjected to vibration such as from
loudspeakers .
Power Connections
The M6 ViNYL is supplied with a standard IEC
mains cable which plugs into the IEC socket at the
back of the unit .
Audio Output Connections
RCA audio outputs:
Use good quality RCA phono
audio cables (fully connected signal and ground),
for optimum signal transfer .
XLR audio outputs
: Use good quality XLR audio
cables (fully connected hot and cold signals and
ground), for absolute optimum signal transfer .
Interconnects
If necessary, please refer to the dealer who can
advise on quality cables for any particular setup.
Musical Fidelity does not endorse any other
manufacturer’s cables .
Cartridge characteristics
For setting the various loading characteristics, the
cartridge manufacturer’s data sheets or setup
information should be consulted .
In a lot of cases the settings are not critical, and
may even be changed to suit personal preference,
if any audible differences are apparent .
No damage will normally occur to an “incorrectly”
loaded cartridge; at very worse a slightly impaired
or nonoptimal frequency response and/or slightly
increased distortion may result .
