HT600 5 Channel power amplifier Instructions for Use. Page 3 of 7
GENERAL ADVICE
INSTALLATION PRECAUTIONS and USER INFORMATION
Your new HT600 5 Channel power amplifier is designed and built to provide trouble-free performance, but as with
all electronic devices it is necessary to observe a few precautions.
ALWAYS disconnect your entire system from the AC mains before connecting or disconnecting any cables,
or when cleaning any component.
The HT600 generates a certain amount of heat and requires ventilation. Do not place it on a soft surface
such as a rug into which it could sink. You should also avoid a built-in installation place such as a book-
case or a rack unless you can provide proper ventilation for the unit.
This product is equipped with a three-conductor AC mains power cord which includes an earth ground con-
nection. To prevent shock hazard, all three connections must ALWAYS be used. if your electrical outlets will
not accept this type of plug an adapter may be purchased. If an adapter is necessary, be sure it is an
approved type and is used properly,
Heed all warnings on the back of the unit.
Only connect the HT600 to a mains outlet of the voltage marked on the back of the unit.
The HT600 will operate in accordance with its specifications as long as the environmental conditions are
kept in the following ranges:-
Temperature
5 to 45 degrees Celsius
Humidity
10 to 90% non condensing
Position the mains lead and all interconnects where they are not likely to be walked on or trapped by items
placed on them.
Do not use near water. The unit shall not be exposed to dripping or splashing and no objects filled with
liquids, such as vases, shall be placed on the unit.
Do not place the unit near direct heat sources such as radiators or other equipment that produces heat.
Do not place the unit where it can be subjected to direct sun-light.
Do not remove any covers or try to gain access to the inside. The warranty is invalid if the unit has been
tampered with. There are no user adjustments within. Refer all service work to an authorised Musical
Fidelity agent.
Dust regularly with a soft duster or soft brush but be careful when using cleaning or
polishing agents - they may harm the surface finish.
NEVER use flammable or combustible chemicals for cleaning audio components.
There are fuses in the unit. In the unlikely event that one blows, take your unit to your audio dealer. Do
NOT try to replace the fuse yourself or you will invalidate the warranty.
No naked flame sources, such as lighted candles, should be placed on the unit.
Keep out of reach of children.
Important! Unauthorised opening of the equipment will invalidate any warranty claims.
Note: To help your dealer identify your amplifier if after-sales service is required, please quote the serial number
located on the rear panel of the unit.
issue 1/12.07.2000
