6
3.2
Not intended use
The possibility of labelling, as well as the durability and quality of the
inscription cannot be guaranteed in the following cases. There is no
guarantee, no warranty and no support.
•
Not provided is labelling of non Murrplastik material.
•
Not provided is using of ink not approved by Murrplastik.
•
Not provided is labelling by means of software which is not approved
by Murrplastik.
•
Not provided is labelling of paper.
3.3
Choosing an installation site
•
Position the unit on a level, stable surface that is larger than the unit
itself. The unit will not operate properly if it is tipped up or tilted.
•
Avoid using locations where the printer will be exposed to extreme
fluctuations of temperature or humidity. Protect the unit from direct
sunlight, excessive light and sources of heat.
•
Avoid using sites that might be exposed to impacts or vibrations.
•
Keep the unit away from dusty areas.
•
Position the unit near to a mains socket, so that no extension cable is
required if possible.
•
When transporting or storing the printer, it must not be tipped up,
stood on one of its sides or turned upside down. Otherwise, the unit
may leak ink.
Summary of Contents for P3B
Page 1: ...ACS labelling systems p b operating instructions As of June 2017 8902865309 ...
Page 53: ...53 Declaration of European Conformity ...
Page 54: ...54 Notes ...
Page 55: ...55 ...
