Murray 1695691, Operator'S Manual

Page: 23 / 156

23
MAINTENANCE
SERVICE RECOMMENDATIONS
PROCEDURE
FIRST
5
HOURS
BEFORE
EACH
USE
AFTER
EACH
USE
EVERY
5
HOURS
EVERY
10
HOURS
EVERY
25
HOURS
BEGINNING
EACH
SEASON
BEFORE
STORAGE
SAFETY
Check to Make Sure
Auger Blade Stops Within
5 Seconds After Right
Control Lever is Released
✓
Lubricate Control Levers
and Linkages
✓ ✓ ✓
SNOW THROWER
Check Snow Thrower for
Loose Hardware
✓ ✓
Lubricate Hex Shaft and
Chains
✓ ✓
Lubricate Auger Shaft
Fittings
✓ ✓
Lubricate Chute Rotation
Gear and Deflector
Mechanism
✓
Remove All Snow and
Slush off Snow Thrower
to Prevent Freezing of
Auger or Controls
✓
Check Tire Pressure
✓
ENGINE
Oil, Check
✓ ✓ ✓
Oil, Change
✓ ✓
Check and Replace Spark
Plug
✓ ✓
NOTICE: If grease or oil comes into contact with the disc drive
plate or friction wheel, make sure to clean plate and wheel
thoroughly with an alcohol base solvent.
CAUTION: Do not allow grease or oil to contact the
rubber friction wheel or the disc drive plate. If the disc
drive plate or friction wheel come in contact with
grease or oil damage to rubber friction wheel will
result.
NOTE: The warranty on this snow thrower does not cover items
that have been subjected to operator abuse or negligence. To
receive full value from the warranty, operator must maintain
snow thrower as instructed in this manual.
The above
Service Recom mendations
are supplied to assist the
operator to properly maintain the snow thrower.
Not
for
Reproduction