Murphy POWERVIEW PV450, Installation And Operation Manual

Page: 6 / 40

Section 78 00-02-0732
2016-02-26 - 2 -
Front Installation of Display
1. Place the back side of the display through the opening in the dash.
2. Use the 4 screws to line up the unit with the drilled holes.
3. Push the unit through the opening and screws through the drilled holes until the back of
the case is flush.
4. Use the Nylock nuts provided to tighten unit to the dash. Use the appropriate wrench or
socket to tighten. Torque lock nuts to 8-10 inch pounds.
Back Installation of Display
1. Cut the dash to allow for the display. Ensure the materials are available to properly
secure the unit within the dash. Torque the 6-32 Nylock nuts to 5 inch pounds.
2. Place the display behind dash and line up the four mounting holes on the display with
the holes in dash.
3. Install four bolts and tighten nuts.
Gimbal Mounted Installation
If it is desired to gimbal-mount the PV450, the gimbals can be sourced from Ram Mounting
Systems, Inc. at www.ram-mount.com
The RAM parts, drawings and models are accompanied by a ordering guide at
http://www.rammount.com/SupportCenter/GlossaryofTerms/tabid/149/Default.aspx
The PV450 has a matching bolt pattern for the RAM Diamond base with 9/16” ball
(P/N RAM-A-238).