Section 78
00-02-0880
2013-05-17
-
5 -
Hardware Installation
The following instructions will guide you through installing the PowerView display.
Inspecting Package Contents
Before attempting to install the product, it is recommended that you ensure all parts are
accounted for and inspect each item for damage (which sometimes occurs during shipping).
The items included in the box are:
•
PV350 or the PV380 unit
•
Dash gasket
•
Installation manual – P/N 00-02-0880
•
Operations manual – P/N 00-02-0879
Dash-Mounted Installation
Tools needed.
•
Jig Saw, or
•
3.5” Hole saw, or
•
3.5” knockout (chassis) punch
Preparing the Dash
Determine the location of the PowerView in the dash. Refer to the Mounting Hole Options
sheet at the end of this document for the appropriate opening sizes.
Mounting the Unit
1. Place the dash gasket over the prepared dash opening.
2. Place the back side of the display through the opening in the dash.
3. Push the unit through the opening until the case is flush.
4. Place the screw on type mounting clamp behind the dash and install on the unit until it is
hand tight.
1-800-548-1191 - http://www.partdeal.com - [email protected]
