Murphy PowerView PV1200, Installation Manual, Page: 10 / 17

Section 78 00-02-1021
2018-07-16 - 8 -
Ethernet (M12) Connector
1
Ethernet TX+
2
Ethernet RX+
3
Ethernet TX-
4
Ethernet RX-
5
Ethernet Ground
NOTE : Ethernet connectivity is optional.
Configuration Information
Follow these steps to download a custom configuration to the PV1200 display:
Step Action
1 Turn off the display.
2 Insert the USB drive that contains the new configuration file into the
display’s attached USB pigtail.
3 Place a magnet onto the spot shown here on the upper right side of the
back of the display:
4 Power the display back on, continually holding the magnet in place.
5 Remove the magnet when the display shows the utility for loading new software.
6 Touch the arrow keys on the screen to select the configuration file from the USB to
be loaded into the display.
7 Start the configuration load by pressing the right arrow/green arrow key on the
screen twice.
8 Once completed, the unit will reboot into the loaded application.
M-12, 5-pos, A-coded,
Plastic Knurl Connector Only