Section 78
00-02-0599
07-19-07 -
3 -
Gimbal Mount Installation
Tools Needed
•
Flathead or Phillips Screwdriver (depending upon screws used for mounting)
•
Drill with 9/64” size bit
•
Hole saw
•
Three (3) 6-32 stainless panhead screws (self tapping or machine screws)
(length = panel thi 0.125”)
Mounting the Unit
1. Determine where the gimbal mount will be located on the dash. Attach the PowerView
to the gimbal mount and tighten the adjustment knob to hold in place.
2. Mark the screw holes needed for the
mount.
3. Drill holes for the mount.
4. Create a “pass-through” hole for the wires
from the unit. This hole can be partially
hidden by the triangle base of the gimbal
mount
IMPORTANT!
Be sure to smooth edges
and install some type of cable protection to
prevent cable chaffing, cuts and abrasions.
Not taking this step could result in failures.
5. Pull the wires through the hole for
connection.
6. Attach gimbal with the bolt and nut
provided.
PHASE
OUT
/ DISCONTINUED
Check
Availability
