00-02-0796
- 28 -
08-26-11
1) There are four selections: Use Factory Defaults,
Serial Port Setup, Slave Address Setup, and Master
Active/Slave Active. You can toggle between
Slave
Active
(which is SCADA/remote Modbus master)
and
Master Active
(which is Auxiliary gages).
Highlight your selection and touch
Enter
.
2) If in Slave Active, select
SERIAL PORT SETUP
and touch
Enter
.
3) Scroll through the
Serial Port Setup
list and make
selections for BAUD RATE, PARITY, DATA BITS,
and STOP BITS to configure the serial port
parameters for your Modbus slave application.
CANBUS Data Rate
Touch
Enter
to reach the six CANBUS data rates. Use the
Arrow Keys
to highlight your choice and touch
Enter
to
make the selection.
Summary of Contents for PowerView PV-101-Cs
Page 2: ......
