Section 80
5
1900003
2019-01-18
USB Overview / Requirements
PowerCore
Products
The PowerCore
products include the MPC20, MPC10, and the TEC-10. The MPC’s are also
used in the ML series panels; ML2000 and ML1000 respectively.
USB Configuration Loading Methods
There are two methods used to load configurations; USB or CAN bus. However, the TEC-10
can only be loaded over the CAN bus.
NOTE:
When loading a new configuration, the original setpoints will be changed
to the setpoints in the new configuration.
USB Thumb Drive
1. UDISK devices are not supported by PowerCore. With the Thumb drive installed, go to:
control panel\device manager\disk drives. Expand disk drives to verify UDISK is not in
the description.
2. Thumb Drive file system must be formatted for FAT. FAT32, EXFAT and NTFS are not
supported by PowerCore. With the Thumb drive installed, go to: computer\removable
disk. Right click on removable disk, click on Format. Check under File System to verify
the format is compatible.
Necessary PowerCore Harnessing for USB Loading
MPC20
Along with the 40000554 3’ 90 pin whip harness, the 40000566 USB programming
harness is required. The 40000566 harness plugs in to the Molex connector on the
40000554 harness.
ML2000
The 40000566 programming harness is included in the ML2000. Remove the four
screws holding the black inner panel to the enclosure. Gently pull the inner panel away
from the enclosure far enough to expose the 40000556 programming harness.
MPC10
Along with the 40000598 3’ 3x12 whip harness, the 78000668 USB programming
harness is required. The 78000668 harness plugs in to the USB receptacle on the back
of the MPC10.
ML1000
The 78000668 programming harness is not included in the ML1000. Remove the four
screws holding the black inner panel to the enclosure. Gently pull the inner panel away
from the enclosure far enough to expose the back of the MPC10. The 78000668
harness plugs in to the USB receptacle on the back of the MPC10.
