Murphy Lube Level Maintainer LM2000, Installation Instructions Manual

Page: 7 / 14

Section 15 00-02-0423
08-12-09 - 3 -
Typical Installation
Mounting the LM2000
The following instructions are based on the usage of the pipe and universal mounting brackets shown on page 1.
Pipe Bracket Mounting (15000238)
1. Mount a nominal 1/2 inch (13 mm) diameter pipe to the base of the engine.
2. Install the pipe bracket to the LM2000 using two 1/4-20 UNC x 1 inch bolts, nuts and lock washers supplied.
See Figure 2A.
3. Slip the LM2000 onto the pipe and install the two adjustment bolts. Each bolt consists of a 1/4-20 UNC x 1 in.
bolt, nuts and lock washers. See Figure 2B. DO NOT tighten the adjustment screws too tightly because you will
have to adjust the LM2000 later in the installation process.
Mounting with Universal Bracket (15000370)
The universal bracket has two mounting methods: base mounting or pan mounting.
Base Mounting
1. Install the universal bracket to the base as shown in Figure 3A using two flat washers and two 5/16 inch dia.
bolts or others as necessary.
2. Mount the LM2000 to the universal bracket using two 1/4-20 UNC x 1-1/4 inch (32 mm) bolts, nuts and lock
washers supplied (Figure 3B). DO NOT tighten the adjustment screws too tightly. You will have to adjust the
LM2000 later in the installation process.
NOTE:
Mount the LM2000 as close as possible to the crankcase.
CAUTION: Excessive vibration can cause overfill. Be sure mounting brackets
are supported.
Figure 2A
Figure 2B
Figure 3A
Figure 3B