-4-
Safety Instructions for Use of Vislider
Warning
1) Do not use power tools for purposes other than the intended use described in their instruction
manual.
2) Vislider should be used with the rated voltage indicated on the nameplate.
•
If this tool is used with a voltage higher than the rating, the motor may rotate at an excessively
high rpm and become dangerous.
•
Conversely, if this tool is used with a voltage lower than the rating, it may reduce performance of
the motor and cause a failure.
•
If something unusual occurs, turn off the power and unplug the Vislider from the outlet. Then
consult the shop where you purchased this product or our sales office.
3) Power tools should be maintained carefully.
•
Oiling and replacement of accessories should be performed in accordance with their instruction
manual.
•
The cord should be inspected periodically. If it is damaged, it should be replaced immediately.
•
Extension cords should be inspected periodically. If the cord is damaged, replace immediately.
•
The handle should always be kept dry and clean. Keep the handle from being soiled with oil or
grease.
•
Be sure to hold the handle firmly while driving screws.
4) Materials that screws are being driven into should be firmly fixed.
•
Use a clamp or vice to hold the material firmly allowing you to hold the power tool with both
hands.
5) If any of the following apply, turn off the power tool and unplug the cord.
•
The power tool is not being used or is in disrepair.
•
An accessory of the power tool is being replaced.
•
There is the possibility of danger.
6) Use an extension cord rated for outdoor use.
When using the power tool outdoors, a cabtyre cable (or a cabtyre extension cable) should be
used.
Minimum gage for cord sets
Volts
Total length of cord [feet]
115V
0-82
85-164 167-328 331-492
Ampere Rating
AWG
(AMERICAN WIRE GAUGE)
0
-
6 6
18
16
16
14
-
10
18
16
16
12
10 -
12 12
16
16
14
12
-
16
14
12
Not Recommended
7) Keep your hands and face away from rotating parts, such as the bit, screws, and the screw
feeding mechanism while operating Vislider as it may cause injury.
8) Be sure to select the correct screws and a tool with an applicable rotating speed. Refer to the
page 5 for details of product specifications.
•
The wrong combination of screws and rotating speed of the tool may overload the motor, which
may result in damage or injury.
•
For details about the applicable tool for your screws, please see our website - www.muro.com,
contact your dealer, or the Customer Service Department of MURO NORTH AMERICA INC..
9) Use only accessories and attachments specified in the manual.
•
Use of an unspecified accessory or attachment not prescribed in the manual or product catalog
may cause accident or injury.
Summary of Contents for VISLIDER VL42-FD
Page 2: ......
Page 18: ...THIS PAGE INTENTIONALLY LEFT BLANK ...
