MURO VISLIDER VL42-FD, Instruction Manual

Page: 5 / 20

-3-
Warning
d) Remove any adjusting key or wrench before turning the power tool on.
A wrench or a key
left attached to a rotating part of the power tool May result in personal injury .
e) Do not overreach. Keep proper footing and balance at all times. This enables better control of
the power tool in unexpected situations.
f) Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
gloves away from moving parts.
Loose clothes, jewelry or long hair can be caught in moving parts.
g) If devices are provided for the connection of dust extraction and collection facilities,
ensure these are connected and properly used.
Use of dust collection can reduce dust-related
hazards.
4)
Power tool use and care
a) Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off.
Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the power tool
before making any adjustments, changing accessories, or storing power tools.
Such
preventive safety measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool.
Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the power tool's operation. If damaged,
have the power tool repaired before use.
Many accidents are caused by poorly maintained power
tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these instructions,
taking into account the working conditions and the work to be performed,
Usage of the
power tool for operating different from those intended could result in a hazardous situation
.
5)
Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
About Double Insulation
Γ
Vislider is constructed of a double insulation structure for the safety of the user.
The double insulation means that the cord and the outer frame are double insulated with two
different types of insulation. This feature offers a superior level of safety against electrical shock.
To maintain the double insulation safety feature, the following instructions must be observed:
1)
If a Vislider part is replaced with a different part or Vislider is reassembled incorrectly, the
double insulation structure may not be maintained and the safety of the product may be
compromised.
2)
The outer frame of Vislider is constructed of impact resistance resin to withstand the rigors
of the job site. However, if it falls from a high elevation or is handled roughly, damage can occur.
3)
Chlorine, solvents, gasoline, and paint thinners can degrade plastics. Do not use them on
the Vislider.
4)
Disassembling and reassembling the electrical system and replacement and/or repair of a
part of Vislider should be requested from the shop where you purchased it or our sales office.