Ver. 1.21
Loading Screws
Ensure the screws are loaded into the CH7392SF with the plastic strip facing like the screw diagram on
the side of the nose.
Screw heads always go in the Top slot, plastic towards the diagram, like the
photo below
and push the strip so that the first screw clicks fully into the barrel. Note that the screws
must be inserted properly for the tool to work. The plastic strip should be able to be centered in the exit
guide. If it is too tight on the top or the bottom, feeding may be impaired.
Fig 7
Driving Screws
To Drive screws: Be sure the screw gun is in forward
. Turn the motor on and
use the trigger lock to
lock it in the on position
. In most cases it is best to have the CH7392SF oriented so that screws feed in
from your right side. Position yourself to operate the tool and
firmly push all the way down until you
hear the clutch disengage
.
Lift completely clear of the surface
and position yourself for the next
screw operation.
Firm pressure is required to keep the bit correctly engaged with the screw
. Do not
yield pressure until you hear the clutch release.
If a screw hits an obstruction or difficulty occurs
when a screw is driven, lift and check that the screws are properly inserted before attempting to drive
another screw.
For best results keep your CH7392SF Ultra Pro Clean and free of dirt and debris for smooth
operation. Blow out or vacuum frequently
.
Summary of Contents for Vislider CH7392SF Ultra Pro
Page 1: ......
Page 9: ...Ver 1 21 ...
