CONTROL
The SEVEN-G-8K has multiple connections
for control. These can be used to control the
SEVEN-G-8K remotely, for FW updates, or for
uploading custom test patterns, audio files, or
video clips. The connections are:
·
IP Control - Use an Ethernet cable to connect the SEVEN-G-8k to a network to access the Web UI.
NOTE: For this to work properly your PC must be on the same network as the SEVEN-G-8K. The
default IP address is 192.168.1.239, but can be changed in the System Setup menu if needed.
·
RS-232 Control - Use a DB9 cable to connect the SEVEN-G-8K to a PC. You can now remotely
control the SEVEN-G-8K via RS-232 protocol. This can also be used to access and use any of the
included SEVEN-G-8K software packages.
·
Serial Link - Use a 3-pin terminal to connect the SEVEN-G-8K to a PC. You can now remotely
13
Connections Cont.
Audio INPUT
2 CH. LINE LEVEL EXT. AUDIO INPUT - Use this 3.5mm
input to connect an external audio source to the SEVEN-G-
8K. This can be used if you have audio test tones or perhaps
music clips from another device.
Audio OUTPUTS
Extracted S/PDIF Audio OUTPUT - Connect the SEVEN-G-8K to
an external audio preamp, amplifier, AVR, or any other device
that has an audio input. Use this to test/confirm audio signals.
NOTE: This is only used to pass the extracted audio from the
HDMI stream. These cannot be used as a “stand alone” audio
output from the SEVEN-G-8K. There are 2 connections:
·
TOSLINK
·
Digital Coax
Summary of Contents for MU-SEVEN-G-8K
Page 7: ...7 ...