-- 6 --
bt29d2e
4.1
Parameter setting
Settings
Setting range
In steps of:
Default value
Welding method
TIG or MMA
--
TIG
2/4--stroke
2 stroke or 4 stroke
--
2--stroke
HF / Lift Arc
t
HF or LiftArc
t
--
HF
Slope down time
0--10 s
0.1 s
1.0 s
Gas post--flow
0--25 s
0.1 s
2.0 s
Current TIG Tradestig 150--1
3 -- 150 A
1 A
100 A
Current TIG Tradestig 200--1
3 -- 200 A
1 A
100 A
Current MMA Tradestig 150--1
4 -- 150 A
2 A
60 A
Current MMA Tradestig 200--1
4 -- 150 A
2 A
100 A
5
INSTALLATION
WARNING!
This product is intended for industrial use. In a domestic environment this product may cause radio
interference. It is the user’s responsibility to take adequate precautions.
5.1
Placing
Place the power source so that its cooling air inlets and outlets are not obstructed.
5.2
Rating plate
The rating plate is located on the rear side of the power source.
5.3
Mains power supply
Make sure that the welding power source is connected to the correct supply voltage
and that it is protected by the correct fuse rating. The standards for the country in
question must be complied with as regards the mains cable area. A protective earth
connection must be made in accordance with regulations.
GB
Summary of Contents for Tradestig 150-1
