NOTICE
This fixture is intended to dispense water that has been lowered in temperature, but otherwise remains
unchanged by the materials in the water cooler. It is common for electrical equipment to be grounded
to water lines either within a structure or away from it. Every attempt should be made to prevent this
kind of grounding from generating electrical feedback into the water cooler creating electrolysis.
Electrolysis will cause a metallic taste or cause water metal content to increase.
IMPORTANT
Prior to roughing consult with local, state, and federal codes for proper mounting height.
A dielectric coupling must be used to connect the water cooler to the water supply . A nonmetallic
coupler is furnished with this water cooler to meet this requirement.
A171408FGVR Wall Mounted Drinking Fountain
ROUGHING-IN AND DIMENSIONAL DRAWING
NOTES:
Dimensions indicated * are for ADA frontal approach installation. Adjust vertical dimension * as
required to comply with federal, state, and local codes. For Child ADA compliant parallel approach,
decrease spout height to 30” maximum above finished floor. Provide clear floor space as required.
A171.8FGVR
Page 2 of 15
Revised:
07/18/18
7020-927-001
MURDOCK MFG. •
15125 Proctor Avenue • City of Industry, CA 91746 USA
Phone 800-453-7465 or 626-333-2543 • Fax 626-855-4860 • www.murdockmfg.com
Member of
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
CONTEMPORARY WATER COOLERS
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
WATER COOLERS
GENERAL NOTES:
1. ALL DIMENSIONS ARE IN INCHES [MM]
2. ALLOW 4 INCHES [102 MM] MINIMUM CLEARANCE PER SIDE FOR VENTILATION
*3. DIMENSIONS SHOWN ARE FOR RECOMMENDED ADULT HEIGHT. ADJUST VERTICAL
DIMENSIONS AS NECESSARY TO COMPLY WITH FEDERAL, STATE, & LOCAL CODES
4. STOP VALVE, P-TRAP, & ELECTRICAL OUTLET NOT SUPPLIED
5. IMPORTANT: COOLERS MUST BE ATTACHED TO WALL WITH APPROPRIATE WALL ANCHOR SCREWS
18
1
2
"
*33
1
2
"
1
3
8
"
10
5
8
"
TAIL
PIECE
7
1
2
"
*16
7
8
"
5
1
4
"
*22
1
4
"
2
1
4
"
4
1
4
"
*16"
14
1
4
"
A. 3/8" NCT SUPPLY INLET
B. WASTE OUTLET FOR 1-1/4" P-TRAP BY OTHERS
C. ELECTRICAL SERVICE ROUGH
D. Ø1/2" HANGER BRACKET PUNCHING, 3 PLACES FOR ANCHORING HARDWARE BY OTHERS
E. Ø5/16" PUNCHING, 2 PLACES FOR ANCHORING HARDWARE BY OTHERS
5"
19
3
8
"
7
7
8
"
6
5
8
"
A
B
C
E
D
AIR FLOW
