This fixture is intended to dispense water that has been lowered in temperature, but otherwise remains
unchanged by the materials in the water cooler. It is common for electrical equipment to be grounded to water
lines either within a structure or away from it. Every attempt should be made to prevent this kind of grounding
from generating electrical feedback into the water cooler creating electrolysis. Electrolysis will cause a metallic
taste or cause water metal content to increase.
Prior to roughing consult with local, state, and federal codes for proper mounting height.
IMPORTANT
NOTICE
ROUGHING-IN AND DIMENSIONAL DRAWING
A dielectric coupling must be used to connect the water cooler to the water supply . A nonmetallic coupler is
furnished with this water cooler to meet this requirement.
A311.8
Page 2 of 9
Revised:
09/01/20
7020-919-001
MURDOCK MFG. •
15125 Proctor Avenue • City of Industry, CA 91746 USA
Phone 800-453-7465 or 626-333-2543 • Fax 626-855-4860 • www.murdockmfg.com
Member of
AIR FLOW
GENERAL NOTES:
1. ALL DIMENSIONS ARE IN INCHES [MM]
2. ALLOW 4 INCHES [102 MM] MINIMUM CLEARANCE PER SIDE FOR VENTILATION
*3. DIMENSIONS SHOWN ARE FOR RECOMMENDED ADULT HEIGHT. ADJUST VERTICAL
DIMENSIONS AS NECESSARY TO COMPLY WITH FEDERAL, STATE, & LOCAL CODES
4. STOP VALVE, P-TRAP, & ELECTRICAL OUTLET NOT SUPPLIED
5. IMPORTANT: COOLER MUST BE ATTACHED TO WALL WITH ANCHOR SCREWS
1
3
8
"
*41
1
8
"
6
1
2
"
5
1
2
"
TAIL
PIECE
ANCHOR
CLIP
6
5
8
"
6
5
8
"
*18
1
2
"
*33
7
8
"
ELECTRIC
OUTLET
*37
3
8
"
15"
1-1/4
WASTE
OUTLET
3/8" SUPPLY
INLET
(2) 5/16"
HOLES
(2) 3/8"
OD HOLES
4"
3"
2"
*35
1
2
"
CONTEMPORARY WATER COOLERS
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
WATER COOLERS
