Murata MEMS Evaluation
Unit User Manual
Murata Electronics Oy
Subject to changes
5/34
www.murata.com
Doc.Nr. 82175700
Rev.D
3
Hardware overview
The MEMS Evaluation Board is shown in Figure 1. The sensor is connected to the evaluation
board with a chip carrier PCB or by using an external interface board. If an external board is used
(see Figure 2), it is connected to a 16-pin extension connector. For extension boards with analog
inclinometer and accelerometer sensors an additional external power supply (from 7 to 15 VDC) is
needed. The external power can be connected to the screw terminals on the MEMS evaluation
board or on the extension board. The USB cable is connected to the USB connector. For more
detailed hardware information, refer to the
and
Figure 1. MEMS Evaluation Board
Figure 2. Extension board (SCA10xT PCB)
Sensor soldered
on PCB
16-pin cable
connector
Screw
terminals for
external power
supply
Temperature
sensor
Sensor soldered
to chip carrier
Reset button
16-pin cable
connector for
extension board
USB connector
Screw terminals
for external
power supply
