Preliminary Specification Number : SP-1SJ-295
2
3
/
2
4
Preliminary & Confidential
< Specification may be changed by Murata without notice >
Murata Manufacturing Co., Ltd.
6. Antenna
The certified antennas include:
PCB pattern Antenna with peak gain 1.0dBi.
Flexible Antenna (Molex: 2111400100) with peak gain 1.0dBi.
7. Label and compliance information
An exterior label on OEM
’s end product can use wording such as the following: “Contains
Transmitter Module FCC ID: VPYLB1SJ
” or “Contains FCC ID: VPYLB1SJ.” In addition, the
following statements shall also appear on the surface of the product.
8. Information on test modes and additional testing requirements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
a)The modular transmitter has been fully tested by the module grantee on the required
number of channels, modulation types, and modes, it should not be necessary for the host
installer to re-test all the available transmitter modes or settings. It is recommended that the
host product manufacturer, installing the modular transmitter, perform some investigative
measurements to confirm that the resulting composite system does not exceed the spurious
emissions limits or band edge limits (e.g., where a different antenna may be causing
additional emissions).
b)The testing should check for emissions that may occur due to the intermixing of emissions
with the other transmitters, digital circuitry, or due to the physical properties of the host product
(enclosure). This investigation is especially important when integrating multiple modular
transmitters where the certification is based on testing each of them in a stand-alone
configuration. It is important to note that host product manufacturers should not assume that
because the modular transmitter is certified that they do not have any responsibility for final
product compliance.
c)If the investigation indicates a compliance concern the host product manufacturer is
obligated to mitigate the issue. Host products using a modular transmitter are subject to all
the applicable individual technical rules as well as to the general conditions of operation in
Sections 15.5, 15.15, and 15.29 to not cause interference. The operator of the host product
will be obligated to stop operating the device until the interference has been corrected.
9. Additional testing, Part 15B disclaimer
The final host/module combination needs to be evaluated against the FCC Part 15B criteria for
unintentional radiators to be properly authorized for operation as a Part 15 digital device.
The host integrator installing this module into their product must ensure that the final composite
product complies with the FCC requirements by a technical assessment or evaluation to the FCC