Preliminary Specification Number : SP-1SJ-295
19
/ 2
4
Preliminary & Confidential
< Specification may be changed by Murata without notice >
Murata Manufacturing Co., Ltd.
1
3
.2 IC Statements
1
3
.3 General Statements
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or
install module.
Therefore, the final host product must be submitted to Murata for confirmation that the installation for the
module into the host is in compliance with regulations of FCC and IC Canada. Specially, if an antenna
other than the model documented in the Filing is used, a Class 2 Permissive Change must be filed with
the FCC.
Changes or modifications not expressly approved by the manufacturer could void the user
’s authority to
operate the equipment.
The LoRa module is for use with external antenna ONLY.
The certified antennas include:
(1) PCB pattern Antenna with peak gain 1.0dBi.
(2) Flexible Antenna (Molex: 2111400100) with peak gain 1.0dBi.
This module has been approved by FCC to operate with the antenna types with the maximum
permissible gain indicated. Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with this device.
ISED RSS Warning/ISED RF Exposure Statement
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.Le
L'exploitation est autorisée aux deux conditions suivantes:L'e
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator& your
body.This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Le rayonnement de la classe b repecte ISED fixaient un environnement non contrôlés.Installation et mise en
œuvre de ce matériel devrait avec échangeur distance minimale entre 20 cm ton corps.Lanceurs ou ne
peuvent pas coexister cette antenne ou capteurs avec d’autres.
IC Label Instructions
The outside of final products that contains this module device must display a label referring to the enclosed
module. This exterior label can use wording such as:
“Contains Transmitter Module
IC: 772C-LB1SJ
" or “Contains
IC: 772C-LB1SJ
” Any similar wording that
expresses the same meaning may be used. l'extérieur des produits finals que contient ce module appareil
doit afficher une étiquette mentionnant le module de ci - jointe.cette étiquette peut utiliser un libellé tel
que:"contient du module
IC: 772C-LB1SJ
ou contient
IC: 772C-LB1SJ
toute formulation semblable qui
exprime la même signification peuvent être utilisés.