9
© Munters Corporation, August 2017
QM1227r4
Figure 7B
Cone
Guard
Guard Ta
4
Guard Tab
Guard Slot in cone
Step 8
Starting at the bottom of the cone, locate one of the guard tabs and put the guard tab through the guard
slot in the cone.
See Figure 7B
. Then work up around the guard and install each of the other guard tabs
in each of the corresponding guard slots. Some force may be required to snap the last tab into the last
slot, pull out on the center of the cone while pushing in on the guard tab until it snaps into place.
Installation Instructions
Chapter 2
Figure 8B
Guard Mounting
Pad
Figure 8A
Nut
Bolt
Guard Mounting Pad
Guard
Fan Outlet
Step 9
If installing your existing guard into the new cone, locate the flat guard mounting pads on the cone and
drill a
9
⁄
32
” dia. hole in the center of each pad. Then insert existing guard into cone with the guard eyelets
facing away from you. Line up each eyelet with a hole in the guard pads. Secure guard to cone using (8)
existing Bolts and Nuts.
See Figure 8A and 8
B
. Tighten all nuts at this time.
Guard eyelet