38
REMOTE CONTROLLER
5. Wire the indoor unit
1 from the rear;
2 from the bottom;
3 from the top;
4 from the top center.
4 methods
PCB
PCB
PCB
PCB
HA HB
1
2
HA HB
1
HA HB
1
2
HA HB
1
2
1
2
3
4
1 indoor unit
2 notch the part for the wiring to pass through with nippers, etc.
Connect the terminals on the remote controller (HA ,HB), and the terminals of the indoor unit
(HA ,HB). (HA and HB do not have polarity.)
Fig 3-6
Putty
Putty
Putty
Trap
Trap
Trap
Fig 3-7
All the pictures in this manual are for
explanation purpose only.
Your wire controller may be slightly
different .The actual shape shall prevail.
6. Reattach the upper part of the wire controller
After adjusting the upper case and then buckle the upper case; avoid clamping the
wiring during installation. (
Fig 3-7
)
NOTE: DO NOT
allow water to enter the remote control.
Use the trap and putty to seal the wires.
