8
Bracket will be oriented towards the outside of the machine and the Pivot Bracket will be located
towards the inside of the machine on both left and right assemblies.
▪
The Conveyor
4’
and Conveyors
7’
have different left side Mounting Bracket Assemblies, the
mounting process is the same.
2.
Place the left Mounting Bracket Assembly onto the machine frame between the frame handle and
motor assembly on the Mother Bucker, and between the frame handle and bucking head left on the
Double Bucker. The Pivot Bracket should be towards the operator side of machine. The support tab
located on the Mounting Bracket will sit on top of the machine frame and inside of the machine frame
handle.
▪
CAUTION
–
Supporting the Mounting Bracket Assembly with one hand while installing the
fasteners is crucial to prevent dropping the assembly and possibly causing injury.
3.
Insert two of
the 3/8” Flathead
Bolts through the
chamfered holes on the Mount Bracket. The
3/8”
Flathead Bolts will align with and pass through two holes
on the Machine Frame.
4.
Install two of the -
3/8” Split Washers onto both the
exposed threaded portion of the 3/8” Flat Head that
passes through the frame. Install two
of the 3/8” Hex
Nuts and tighten to hand tight.
5.
The right-side Mounting Bracket Assembly mirrors the left side assembly
6.
With both left and right Mounting Brackets installed
with all four fasteners hand tight, use a 9/16”
socket or end wrench and a 7/32” Hex key to tighten nut until the Split washers are
pinched flat
between the nut and machine frame.
Conveyor 4’
Mounting Bracket
configuration
Conveyor 7’ Left & Right
Mounting Bracket
configuration
