Multiva FX300 SeedPilot, Operation And Maintenance Manual

Page: 150 / 208

7.1.14. Checking the functioning of the adjusting of fertiliser target
rate
Figure. 7.1.14. - 192. Checking the functioning of the adjusting of fertiliser target rate On the left, a machine
without a gearbox and, on the right, a machine equipped with a gearbox on the seed side (basic model). On the
right, a machine with a dual gearbox (machine with gearbox).
1. Enable the adjusting of fertiliser target rate and ensure that the pointer (2, 4) moves on
the fertiliser feeding quantity scale (1, 3).
On the basic model, the adjustment only moves when the seed shafts rotate. On
the machine with gearbox, the adjustment moves even when the seed shafts do
not rotate.
7.2. Lubrication
After the commissioning of the machine, all lubrication points should be lubricated
after the rst 10 hectares.
The coulter discs are equipped with permanently lubricated bearings, which do not
need to be lubricated.
When lubricating, make sure that the grease nipple is open. Lubricate the point until
grease ows out of the joint. Usually, 1-2 squeezes of a grease gun is enough for the
grease nipples. Wipe off excess grease.
Use lithium-based lubricating grease for lubrication. The chains are lubricated with
high-quality motor oil.
The use of heavy, long- bre greases and greases containing solid lubricant particles
(molybdenum sulphide and graphite) is prohibited.
Operation and maintenance manual
FX300 and FX400 SeedPilot
1.00
150 (208)